HIGH VOLTAGE BATTERY – Remove & Replace – Hybrid Battery – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.] USE CUSTOMERS OWN PART
KELLY L. gave our service a 5 star review on 4/3/2024
Inspected A/C Blower mode and temp controls working Static pressure 50 PSI, Ambient temp 65° Low 8 PSI high 70 PSI Vent temp 75° Found visible leak from the high side hose. Recommend replace the high side hose Evac and recharge to capacity and recheck Replaced high side hose hose, evac and Recharged Low 30 PSI high 150 PSI Ambient temp 74° Vent temp 43°
AIR COND HOSE – Remove & Replace – Compressor Hose,Assembly – [Includes: R&I Bumper Cover.] – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
EVACUATE AND RECHARGE A/C SYSTEM
Melani D. gave our service a 5 star review on 3/29/2024
INSPECT FOR FAINT RUBBING NOISE WHEN REACHING SPEED OF ABOUT 40MPH
1. Cycle Oil System Cleaner for 15-30 minutes Idle/Drive Time; to Remove Sludge, Neutralize Acid, Break Down Carbon and Clean Anti-Smog Valves by Vapor Action. 2. Remove the Drain Plug and Drain the Crankcase to Remove the Used Oil and Contaminants from the Oil System. 3. Remove the Oil Filter. Inspect for Obvious Damage, Corrosion and Contamination. 4. Install New Oil Filter to Help Reduce Foreign Object Deposits in the Oil System (Replace Applicable Gaskets and Seals). 5. Inspect the Drain Plug Gasket (Replace If Needed). 6. Install the Drain Plug and Torque to Factory Specification (Remark Torque Line If Faded). 7. Use JB Engine Oil Supplement in the Crankcase to Condition the Metal and Reduce Friction Drag Between Moving Parts. 8. Fill the Crankcase Engine Oil with the Manufacturer Specified Oil to Properly Lubricate the Components Throughout the Entire Oil System. 9. Use One Bottle of Justice Brothers Fuel Injection System Cleaner in the Gas Tank to Stabilize the Fuel, Clean the Fuel lines, Fuel Filter, Injectors, Remove Water and Contaminants from the Fuel System. 10. Complete Vehicle Inspection. (Inspection Results Digitally Transferred upon Completion of Inspection). 11. Reset All Maintenance Lights, Disinfect Surfaces.
1. Pour Entire Contents JB Radiator Cleaner in the Existing Coolant/Water. 2. Cycle Radiator Cleaner For 15-60 Minutes at Normal Operating Temperature to Neutralize Acids, Dissolve Corrosion Build Up, and Improve Fluid Circulation. 3. Drain Used Coolant/Water and Cleaner to Remove the Harmful Contaminants. 4. Fill the Cooling System with Manufacturer Recommended Coolant (Antifreeze) to the Manufacturer Specified Fluid Level. 5. Use JB Cooling System Protector & Water Pump Lubricant to Condition the Metal, Provide Lubrication to the Water Pump, Prevent Rust, And Hold the PH Balance of the Coolant. 6. Pressure Test Cooling System, Check for Leaks and Proper Operation.
JAMES A. gave our service a 5 star review on 4/1/2024